Brick and Mortar Scarf
Brick & Mortar Scarf
A cozy, oversized scarf, woven from Mallo Cotton Slub Yarn.
You can download an updated version of this pattern and purchase a kit here.
Designed for multi-shaft weavers by Mariah Gaar for Gist Yarn.
Need some help getting started? Check out Resources for Beginner and Intermediate Weavers.
Materials
Warp & Weft: 4 cones of Mallo Cotton Slub
Project Notes
- Tools Required: 4 shaft table or floor loom, or rigid heddle loom*, 10 dent reed, shuttle & bobbins, fringe twister (optional)
- EPI: 10
- PPI: 20
- Width at Reed: 24"
- Warp Ends: 240
- Warp Length: 3 yards
- Technique/Draft: Swedish Point from A Handweaver's Pattern Book by Marguerite P. Davison (see draft below)
- Finished Dimensions: 18" x 70" + 6" fringe on each side
- Finishing Details: Hemstitch, 6" fringe on each side
- Care Instructions: Hand wash cold with mild soap, hang to dry, press as needed
- Note: *To weave a similar version of this project on a rigid heddle loom see our variations section below.
Weaving & Finishing
Warp Color Order: Wind a warp in the following sequence for a total of 240 warp ends.
- Color A - 40 ends (4")
- Color B - 20 ends (2")
- Color C - 180 ends (18")
Weft Color Order: Begin and end the scarf with a few picks of plain weave and hemstitch. Follow the weft color order below.
- Color A - 4"
- Color B - 2"
- Color C - 61"
- Color B - 2"
- Color A - 4"
Threading Order: Repeat the pattern block of 12 ends a total of 20 times (see draft below).

Finishing: In loom your scarf should measure approximately 21" W x 73" L (with room for 6" of fringe on both ends). Wet finish in cold water with a mild detergent, roll up in a towel to absorb excess water and hang to dry. Trim fringe to 6" on each side.
Variations
- Create your own stripe pattern throughout the warp and weft.
- To weave a similar version of this project on your rigid heddle loom, simply weave the scarf in tabby (plain weave), or try a method with a pick-up stick and warp floats (see this post by Liz Gipson on Knitty for reference).
About Mariah Gaar
"I have a background in Studio Art -- specifically in fibers and graphic design. In my own work, I aim to create access to heirloom quality textiles. I explore various natural fibers and color combinations to make something worthy of holding on to. I focus on the juxtaposition between art and function - and try to find the balance between the two. Weaving is my passion and I enjoy continuing to learn more about this medium every day."
